Hi. This is a tutorial on how to set up HDMI DMA fuser. Your DMA card must be installed in the PC. I express a lot of the main PC. If your resolution is full HD 60 hz, then you can skip this instruction. In this case, you just need to connect user recording image and use it. If you have different monitor resolution or Heritz, then follow this instruction. 1ST put the DMA fuser aside well, need it later, connect an HDMI cable directly from the main computers video card to the main monitor. Also connect the 2nd monitor directly to the video card of 2nd computer. With any cable, go to display settings. Set the scale of the interface to 100 %. Select the desired screen resolution, set the desired monitor hertz. In my case it is 120 hz. Do the same on the 2nd monitor.
Next, installed the me. Set a program on your main computer, installing it, run it..Click on the 1st line, go to file Save as and save your monitors conflict to your desktop. Next, connect these to HD at my cables, as well as the U-S be cable to flash the DMA fuser, as noted in the picture.
Now turn on the DMA fuser, using the button, start the injector program..Now go to device Manager to find out in which slot the Fusor flash cable is plugged in. Look for a device named USB cereal. I have it labeled com for So in the injector, I select the same Next, select the resolution of your monitor. In my case, it is 2560 by 1440. You press this button, then click here and select the conflict file of your monitor, which you created earlier, and click on this button to inject. I will not click, as I already have my monitor set to the right resolution and frequency. The injection will take about 30 s and your monitor will go up for that time. After that, you need to connect last HDMI cable to DMA fuser, the other end of which plugs into the video card of the 2nd computer. If the main computer monitor does not turn on automatically, you will need to press the key one button and wait 20 s This button changes the resolution to DMA fuser. If the main monitor still doesn't work, continue to press the K button for seconds until the image appears. Now let's check how the DMA fuser works. Press the cave for button, and the image from the 2nd monitor should be transmitted to the main monitor.
As you can see, everything works..In order to find out the current resolution and hurts in which fusor is working, you need to hold the key, one button for 3 S and release it. It was an instruction for setting up the Fusor the rest of the videos with instructions on setting up the firmware DMMA card Kmbox and running the cheat You can find on this youtube channel. Don't forget to subscribe to our youtube and telegram channel. We have a lot of useful information about DMA fuser.