To ensure optimal performance of the D60 4K Fuser, users may update the firmware by following the steps below. Please make sure to install the CH340N driver before upgrading, otherwise the software will not recognize the device port.
In the firmware update interface shown in the image, begin by selecting the corresponding CH340 COM port in the upper-left port selection area (for example, COM3; the actual port number depends on your computer). After confirming the port, choose the “BIN” option according to the file extension of your firmware.
Next, click the “...” button located at the upper-right corner to browse for the firmware file. Locate the directory where you stored the firmware, select the file, and click “Open” to load it into the program.
Once the file is loaded, click the “Send” button on the right side to start the firmware writing process. At this time, the indicator light on the D60 Fuser will turn green, indicating that the device is updating. Please keep the USB connection stable until the message “Send Completed” appears in the lower-left corner of the software.
After the completion message is displayed, you may turn off the fuser and disconnect the USB cable. Your D60 4K Fuser has now been successfully upgraded.
Firmware Tool Download:
https://wwsw.lanzouo.com/b00q01fu3c
Password: 6666